-Pentium III 900MHz
-512 MB RAM
-40 Gig IDE hard drive
Ok, so at the server terminal screen I see this:
XERGE:_
Which is the terminal prompt, duh, as I know Linux and obviously "Xerge" is the server name.
Ok, now when I try to load disk drivers using the command LOAD IDE (I'm assuming this is correct since it is an IDE hard drive) I then get:
Loading module IDE.DSK
NetWare IDE Device Driver
Version 3.12 April 26, 1993
Copyright 1993 Novell, Inc. All rights reserved.
Supported I/O port values are 1F0, 1E8, 168
I/O port: 1F0
Then leaving the 1F0 part and pressing enter, I then get:
Supported interrupt number values are E, F, C, A
Interrupt number: E
I then leave it default and press enter and I'm back to the XERGE: prompt. From which I issue the command:
LOAD C:\SERVER.312\INSTALL
Which runs the INSTALL program. Then under the Installation Options menu, I go to Disk Options, then Partition Tables but then I ALWAYS get:
There are no accessible disk drives, check to see that the drives are properly attached, turned on, and that the correct disk drivers are loaded. Press ALT-ESC to switch to the console screen if you need to load a disk driver. (Press ESCAPE To Continue)
Any idea? I'm probably going to check about NetWare 5.1 tomorrow since I'm sure we're not running it and so the license should be able to be used. I'm not a Novell NetWare expert and any assistance is really appreciated! I need to learn NetWare for a class (actually a club in which we compete at state and national levels) and right now, I'm stuck!
Thanks!
[N]F


